7 - 105
7 MOTION PROGRAMS FOR POSITIONING CONTROL
[Program Example]
The program for which executes the positioning in the exact stop check mode.
1) G61 G01 X100. F500. ; (Positioning in the exact stop check mode)
2) X200. ; (Positioning in the exact stop check mode)
3) X300. ; (Positioning in the exact stop check mode)
X-axis
V
t
1) 2) 3)
REMARK
Only the high-speed feed rate may be the specified speed in G00. To specify the
speed every time point-to-point positioning is executed, you can use G61 and G01.
To Next Page
Loading...
