7 - 160
7 MOTION PROGRAMS FOR POSITIONING CONTROL
REMARK
(1) The mark of the I/O modules is X and Y in SV43 regardless of installation/non-
installation. PX and PY is not used in the Motion program.
(2) Writing in the device X is possible only for the range of the input modules non-
installation.
(3) The start accept flag (M2001 to M2032) must not use IF, THEN and SET/
RST/OUT.
(4) Do not write it in special relay (M9000 to M9255) excluding the user setting
device.
(Note) : The device range which can be used by "IF, THEN, SET/RST/OUT" and
"SET/RST" is the same.
To Next Page
Loading...
