3 - 5
3 COMMUNICATION BETWEEN THE PLC CPU AND THE MOTION CPU IN
THE MULTIPLE CPU SYSTEM
2) Set the CPU-side device as follows.
• Settings 1 to 4 may use different devices.
If the device ranges do not overlap, the same device may be used for
settings 1 to 4.
Setting 1: Link relay
Setting 2: Link register
• Settings 1 to 4 may use
different devices.
Setting 3: Link relay
• The same device may be used for
settings 1 to 4.
In setting 1 shown to the left, 160 points
from B0 to B9F are used. Therefore,
setting 3 can use device No. after BA0.
Device numbers may not overlap even
partially, such as specifying B0 to B9F
in setting 1 and B90 to B10F in setting 3.
• The first and last addresses are calculated
automatically in SW6RN-GSV43P.
To Next Page
Loading...
