Mitsubishi Electric QJ71C24N-R4 - List of GX Developer Setting Items for Serial Communication Modules

3 - 19 3 - 19
MELSEC-Q
3 SPECIFICATIONS
3.7 List of GX Developer Setting Items for Serial Communication Modules
The following table lists the parameters that are set using the GX Developer.
Parameter setting item Parameter description Set data Reference section
I/O assignment setting
Performs I/O assignment
for the Q series C24 and
enables the switch settings
listed below.
Type
Section 4.5.1
Model name
Points
Start X/Y
Switch setting
Switch 1
CH1 Transmission setting
Section 4.5.2
CH1 Communication rate setting
Switch 2 CH1 Communication protocol setting
Switch 3
CH2 Transmission setting
CH2 Communication rate setting
Switch 4 CH2 Communication protocol setting
Switch 5 Station number setting
Interrupt pointer setting
Performs setting for reading
reception date with interrupt
programs.
CPU side
Interrupt pointer Start No.
Section 4.5.3
Interrupt pointer No. of units
Intelligent
module side
Start I/O No.
Start SI No.
Remote password
settings
Sets the remote password
and the Q series C24 that
performs the check.
Password settings
User's Manual
(Application)
Password active
module settings
Model name
Start XY