Raising Headlamp
When the Pop-up Switch is Turned From OFF to
ON and the Lighting Switch is OFF or at TAIL
When the pop-up switch is turned ON, the judgment
circuit in the ETACS control unit senses the ON signal
and activates the UP timer circuit. Then, since transistor
Tr1 is turned ON, transistor Tr2 is also ON, current from
transistor Tr2 flows through the U-contact in the pop-up
motor U/D (UP/DOWN) switch and from the pop-up
motor relay (coil side) to earth, the pop-up motor relay
(contact side) goes ON, current flows in the pop-up
motor and the headlamp starts to go up.
When the crank arm rotates approximately 180
0
and
reaches the UP position where it stops automatically,
current to the pop-up motor is cut off since the con-
necting U/D switch contact changes from the U-contact
to the D-contact, the pop-up motor stops and the head
lamp remains in the up position.
indicates a model with the theft-alarm system installed.
indicates models without a theft-alarm system.
NOTES
(1) The dotted line
(2) The two-dotted line
16F0109
7 -10
ELECTRICAL - Lighting
To Next Page
Loading...
