Front roll
stopper
MOUNTING
ENGINE -
Mounting
The engine mounts use a principal axis inertia support
system.
This support method on the principal axis inertia is a
structure that supports the top of the engine and top of
the transmission to effectively control engine vibration.
A dynamic damper is provided on top of the engine
mount to cut out high-frequency noise.
Roll stoppers (front and rear) are installed on the
crossmember that is elastically supported on the body to
reduce transmission of engine vibration to the body.
The various mounts have the following features
• Each insulator has a hole to effectively absorb small
and large vibrations.
Insulator
Insulator
Hole
01N0101
R
No. 1 crossmember
Front
~
1-6
Insulator
Engine
mount
No.2 crossmember
Front
~
Rear
roll
stopper
Front roll
stopper
F
7
Insulator
Dynamic
damper
No.1
crossmember
Hole
No. 2
crossmember
01 F0014
N
To Next Page
Loading...
