INPUT INSPECTION FUNCTIONS OF ETACS
The ETACS control unit has an input inspection function that can
check everything from each switch to the ETACS control unit by
using a multi-use tester to measure the voltage variations at the
ETACS terminals on the diagnosis connector.
The diagnosis connector is installed on the side of the junction block
on the lower left-side of the instrument panel.
The ETACS input inspection function has the following functions.
(1) Ignition switch (ACC and ON)
(2) Wiper switch (I NT)
(3) Variable intermittent wiper control switch
(4) Washer switch
(5) Key reminder switch
(6) Door switch
(7) Door lock switch
(8) Defogger switch
(9) Pop-up switch
ELECTRICAL - ETACS 7-29
To Next Page
Loading...
