section and output shaft. The output shaft has a high
torque output because the high revolutions of the
micro-motor are reduced by the deceleration gear.
12F000
6
Deceleration gear
Position detection
switch
12 F0053
Damping force
changeover
actuator
DRIVE-CONTROL COMPONENTS - Electronic Control Suspension (ECS)
-
CTUATOR
ECS Indicator Lamp
There is an indicator lamp (green) to indicate the mode in the
combination meter. When a breakdown is detected, it flashes at
intervals of 0.5 second to warn the driver.
Mode TOUR SPORT When breakdown
TOUR lamp ON OFF
Flashing
SPORT lamp OFF ON
Flashing
Damping Force Changeover Actuator
The damping force changeover actuator is built into
the front and rear shock absorbers and designed for
compactness, lightweight and reduction of mounting
space. It is made up of the micro-motor section,
deceleration gear section, position detection switch
Micro-moto
Output shaft
To Next Page
Loading...
