Tilt lever
TILT STEERING CONSTRUCTION
The tilt steering consists of the tilt lever, tilt bolts (A,
B), tilt bracket and column plate, etc. The tilt bolts (A,
B) are attached to the end of the tilt lever; tilt bolt A
has right threads and tilt bolt B has left threads, and
the tilt bracket is pressed and fixed to the column
plate with the tilt bolts (A, B).
TILT STEERING OPERATION
(1) If the tilt lever is lowered to the free position, the tilt bolts (A,
B) move in the loosening direction (outer side) so the
steering column can be slid up and down.
(2) If the tilt lever is pulled up to the lock position, the tilt bolts (A,
B) move in the tightening direction (inner side) so the tilt
bracket is pressed to the column plate, fixing the steering
column.
Steering column
Cross section A-A
Tilt bracket
Column plate
Tilt bolt B
3-24 DRIVE-CONTROL COMPONENTS - Power Steering
Tilt bolt A
. Lock
Free
Tilt lever
13F0021
13F0016
To Next Page
Loading...
