I
0
Regardless the touch-switch
fwwticm
is
setorn~t,
w)sentnndt@le
touch switches
(two
places or
more) are pressed.simultaneously as shown in the following diagram, the
GOT
is designed to
execute
a
pre-defined
operation
of
the
touch
switch
if
a
touch
switch function
is
deMci
at
the
fourth vertex of the rectangle.
When three touch swiches are Dressed: When four touch swiches
are
Dressed: When four touch swiches are Dressed:
:
Indicates touches position.
0
:
Indicates
the
switch recognized
by
the
GOT.
#
:
Indicates a
touch
switch.
:
Indicates the touch switch that executes the
set
action.
When multiple touch switches
are
pressed simuttaneously under the conditions described above,
make sure
that
the
system
works
safely
by carefully considahg the
location
of
each
touch
switch
function and adding an interlock circuit to the write device using a sequence program, etc.
A
malfunction might cause a breakdown, accident, or damage to the machine.
ACAUTDN-
communication cables
and
bus
connection
cables
with the
main
circuit
or
power wires, or install
them
close to each other.
They
should
be
installed
lo0
mm
(3.9
inch) or
more from each other,
Failure
to do
so
may result
in
noise that
would
cause
malfunctioning.
[INSTALIATION
PRECAUTIONS]
ACAUTION
0
Make sure to switch all phases of the external
GOT's
power supply
off
before installing or remov-
ing the
GOT
main module to/from the base.
If you do not switch
off
the external power supply,
it
will cause failure or malfunction
of
the
module.
0
Make sure to switch all phases of the external
GOT's
power supply
off
before mounting or remov-
ing the power supply module, communication module, bus conectbn module, optional module,
memory cassette, and memory card to/from the
GOT
main module.
If you do not switch
off
the external power supply,
it
will cause failure or malfunction of the
module.
0
Make sure to switch all phases of the external
GOT
and
PC CPU
side power supply
off
before
connecting the communication cable and bus connection cable to the communication module
and bus connection module.
If you do not switch
off
the external power supply,
it
will cause failure or malfunction of the
module.
To Next Page
Loading...
