r
ACAUTION
0
Use
the
GOT
in
the environment given
in
the general specifications of the
GOT
User's
Manual.
Using
the
GOT
wtside
the
range
of
the general specifications may result
in
electric
shock, fire or
malfunctioning, or may damage or degrade the module.
0
Tighten the attachment screws for installing the
GOT
main module to the base within the range
of
specified toque.
If the attachment screws are loose,
it
may result in fallout, short circuits,
or
malfunctions.
Tightening
the
attachment screwes too far may cause damages to the screws and/or the module,
resulting in fallout, short circuits, or malfunctions.
0
When using a bus connection, bus connection cables should be securely connected to the con-
nectors of the bus connection module, bus connector conversion module, and base unit. After
connecting the connector, check to make sure they are securely
tightened
and
not loose. Defec-
tive contact could cause a false input and output.
0
The communication cable should
be
connected securely to the connector on the communica-
tions module and PC CPU side. After connecting the connector, check to make sure they are
securely tightened and not loose. Defective contact could cause a false input and output.
0
When the power supply module, communication module, bus connection module, and the
op-
tional module are installed to the
GOT
main module, attach them to the
GOT
attachment part by
aligning to the screw guide, then tighten the module fixed screws within the range of specified
torque.
If the module fixed screws are loose,
it
may result in fallout, short circuits, or matfunctions.
Tightening the module fixed screws too far may cause damages
to
the screws and/or the mod-
ule, resulting in fallout, short circuits, or malfunctions.
0
Make sure the memory cassette and memory card are installed securely in their connector. After
connecting the connector, check to make sure they are securely tightened and not loose. Defec-
tive contact coule cause malfunctions.
WIRING
PRECAUTIONS]
0
Make sure to switch
all
phases of the external
GOT'S
power supply
off
before beging wiring work.
If
you do not switcn
off
the external power supply,
it
will cause electric shock, malfunction, or
damage to the module.
I
To Next Page
Loading...
