Mitsubishi 800 Series - 5.4.4 Installing a network module

,
., .
5. Handling Component Equipment Modules MELSEC GOT
5.4.4 Instatling a network module
This shows how to install a network module in the GOT. For more detailed information on network
module specifications and settings, please refer to the A7GT-J71 LP23/BR13 User’s Manual and
the MELSECNET/lO Network System Reference Manual
(For PC Networks).
1 DANGER
0 Before installing a network module in the GOT, or removing a module already in-
stalled, switch all phases of the external power supply
off to the GOT.
I Reverse surface of GOT I
Netw
Reverse surface
of network
module
*
STATION
Network unit LED section
@ Install the network module to the GOT, then fix it in place by
tightening the screws
of the network module within the range
of specified torque, 39 to 59 Ncm
(4 to 6 kgcm).
To remove the network module, loosen the screw, and then
reverse the installation procedure.
@ Connect the link cable to the network module.
For instructions on connecting a coaxial cable, please refer to
the MELSECNET/lO Network System Reference Manual (For
PC Networks).
@ Set the mode change switch of the network module to the
Test
Mode.
@ Turn on the power supply to the GOT and run a link test of the
network.