4.
Names
of
Parts
and
Their
Settings
MEiSK:
GOT
4.
Names
of
Parts
and
Theirs,§eMings
4.1
GOT
Main
Module
0
l
0-
0-
63-
03
No.
I
Name
Remarks
Contents
0
-
Interface for installing the memory card Memory card interface
@
-
Displays monitor screens
Display module
@
1
Ratings plate
I
-
I
-
Interface for connecting op-
tional module
I
Interface for connecting optional module
Indicates whether or not memory card can
be
installed.
Not lighted
-
Memory card can be installed (when switch
@
is
Lighted
-
Memory card cannot be installed (when switch
@
is
on)
If
memory
card
is installed while power is
on,
this
specifies
memory
OFF setting
card access status.
Memory
card
access switch ON
-
Access from GOT to memory card is disabled.
OFF
-
Access from GOT to memory card is enabled.
ON setting
(This is set
to
OFF when ShiDDed from the factow.)
o>
Memory card LED
-
off)
D
@
I
Reset switch
I
Resets the GOT hardware
\
With cassette cove1
@
I
Memory cassette interface
I
Interface for connecting the memory cassette
I
-
Communications module in- Interface for connecting a communications module
terface
1
Communications module in-
-
Interface for connecting a communications module
Screw hole for attaching Screw hole for securing a communications module
to
the GOT
communications module
@
I
RS-232C interface
I
RS-232C interface for connecting a computer
*'
I
-
@
-
trol panel or other component, the hook
of
the attachment fitting
Fitting
for
attaching
main
module
@
-
RS-232C interface for connecting a power supply module Power supply module interface
When the attachment fitting is used to attach the GOT to a con-
is inserted here
to
secure it.
0
1
power supply module
Screw
for
attaching
1
Screw hole used to secure the power supply module
to
the GOT
1
*l
The connector used for the RS-232C interface that connects the computer should have a maximum thickness of
16
mm.
(Suggested connector: 17JE-23250-02 (D8A6))
If
the connector has a thickness that exceeds
16
mm, it will not fit the RS-232C interface.
4-1
To Next Page
Loading...
