63
WT07627X03
[From external system]
AE-50
AE-50
AE-50
AE-200
(A) When the Peak Cut method [PLC Software for Demand Input] is selected
1st page
2nd page
(1) In the [IP address of PLC] field, enter the IP address of the Demand-Input PLC.
(2) When using the Demand-Input PLC for the first time, initialize its internal memory.
Note: Do not initialize the Demand-Input PLC after the operation has begun, for it will reset all settings to the default settings
and will not properly perform the Peak Cut control.
Demand level
signal is sent.
PLC etc.
Pulse
Pulse-watt-
hour meter
Maximum ten
AE-200/AE-50/EW-50 units
Peak Cut method
IP address of PLC
Temperature difference
between set point and
inlet
Initialize
Save Settings
IP address of controller
Save Settings
To Next Page
Loading...
Need help?
General
