9
WT07627X03
Initial settings for AE-200/AE-50/EW-50 can be configured on the LCD, Initial Setting Tool, and Web Browser for
Initial Settings.
Each has specific characteristics as below.
• LCD
Method for setting the AE-200/AE-50/EW-50 from the AE-200’s LCD.
Configuration of initial settings for single AE-200 systems is possible.
Methods of setting from the LCD are explained in section 5 “Settings on the LCD”.
Note: Configure the expansion controller connection settings from the AE-200’s LCD.
Note: The EW-50 does not have an LCD, therefore it is necessary to configure settings from either the Initial Setting Tool or
Web Browser for Initial Settings.
• Initial Setting Tool
The Initial Setting Tool is used for configuring settings from a PC.
This allows configuration of initial settings for multiple AE-200/EW-50 systems, and allows batch configuration
of initial settings for up to a total of 40 AE-200/AE-50/EW-50 units.
A check sheet can be output to be used for trial runs.
The settings data created using the Initial Setting Tool is written from the PC to the AE-200/AE-50/EW-50 over
a LAN connection. Additionally, settings data can be created beforehand at another location such as an office.
Methods of setting from the Initial Setting Tool are explained in section 6 “Settings using Initial Setting Tool”.
Note: It is necessary to set the apportioned electricity billing function initial settings and Integrated Centralized Control Web
function initial settings from the Initial Setting Tool.
Note: It is necessary to set the BACnet
®
connection function initial settings from the BACnet
®
Setting Tool.
• Web Browser for Initial Settings
The Web Browser for Initial Settings is used for configuring settings from a PC Web browser.
This allows separate logins to a single AE-200/AE-50/EW-50, and configuration of initial settings.
Methods of setting from the Web Browser for Initial Settings are explained in section 7 “Settings using Web
Browser for Initial Settings”.
To Next Page
Loading...
Need help?
General
