Mitsubishi AJ65BT-R2N-U-HW - 5 Wiring; CC-Link Dedicated Cable Connection Method

17
5. WIRING
5.1 CC-Link Dedicated Cable Connection Method
The following shows how to connect the AJ65BT-R2N to a master
module and a remote module with CC-Link dedicated cables.
POINT
For wiring of the module, refer to SAFETY PRECAUTIONS
provided at the beginning of this manual.
Figure 5.1 Connection between AJ65BT-R2N and master module
POINT
Be sure to connect terminating resistors, which are supplied with the
master module, to modules on both ends of the data link network.
(Connect it between DA and DB.)
Master module
CC-Link dedicated cable CC-Link dedicated cable
DA
DB
DG
SLD
FG
DA
DB
DG
SLD
24V
24G
FG
DA
DB
DG
SLD
24V
24G
FG
AJ65BT-R2N Remote module
(Blue)
(White)
(Yellow)
Terminating
resistor
Terminating
resistor