Mitsubishi ASX 2016

Service reminder
When the time for periodic inspection ar-
rives, the warning display is displayed for a
few seconds after the ignition switch or the
operation mode ON screen. Refer to “Service
reminder” on page 5-16.
Type 1
Type 2
Drive mode indicator display
screen*
E00520800303
This displays the 4WD sta-
tus.
If you select “4WD LOCK”
mode with the drive mode
selector, “4WD LOCK” is
displayed; if you select
“4WD AUTO” mode,
“4WD” is displayed.
Nothing is displayed when
2WD mode is selected. Refer
to “Drive mode selector” on
page 6-39.
mark display screen (when
the ignition switch or the oper-
ation mode is ON)
E00520900333
This is displayed when you
press the multi-information
meter switch and switch the
warning display screen.
This mark is also displayed
if there is another warning
other than the one displayed.
When the cause of the warning display is
eliminated, the
mark goes out automatical-
ly.
Type 1
Type 2
NOTE
l
When the mark is displayed, the warning
display screen can be redisplayed on the in-
formation screen.
Refer to “Information screen (when the igni-
tion switch or the operation mode is OFF)”
on page 5-05.
Refer to “Information screen (when the igni-
tion switch or the operation mode is ON)”
on page 5-10.
Active Stability Control (ASC)
OFF display screen*
E00521000373
This is displayed when the
Active Stability Control
(ASC) is turned off with the
ASC OFF switch.
If there is a fault with the
ASC, the ASC OFF display
is shown.
Refer to ““ASC OFF” switch” on page
6-52.
Multi-information display
5-09
OGAE15E5
Instruments and controls
5