Mitsubishi ASX 2016

Dipper (High/Low beam
change)
E00506200329
When the lamp switch is in the “
” posi-
tion, the beam changes from high to low (or
low to high) each time the lever is pulled
fully (1). While the high-beam is on, the
high-beam indication lamp in the instrument
cluster will also illuminate.
Headlamp flasher
E00506300199
The high-beams flash when the lever is
pulled slightly (2), and will go off when it is
released.
When the high-beam is on, the high-beam in-
dication lamp in the instrument cluster will il-
luminate.
NOTE
l
The high-beams can also flash when the
lamp switch is OFF.
l
If you turn the lamps off with the headlamps
set to high-beam, the headlamps are auto-
matically returned to their low-beam setting
when the lamp switch is next turned to the
“ ” position.
Welcome light*
E00528901642
This function turns on the position and tail
lamps for about 30 seconds after the UN-
LOCK switch (A) on the remote control
transmitter is pressed when the combination
headlamps and dipper switch is in the “OFF”
or “AUTO” position (for vehicles equipped
with the automatic lamp control). On vehicles
equipped with automatic lamp control, the
welcome light function will operate only
when it is dark outside the vehicle.
NOTE
l
While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
•
Push the LOCK switch (B) on the remote
control transmitter.
Combination headlamps and dipper switch
5-52
OGAE15E5
Instruments and controls
5