To return to the original position, push it
backward level with the seat.
NOTE
l
Do not climb or sit on the armrest. Doing so
could damage the armrest.
l
The top surface of the armrest contains a cup
holder for rear seat occupants.
Refer to “Cup holder” on page 7-81.
Head restraints
E00403301439
WARNING
l
Driving without the head restraints in
place can cause you and your passengers
serious injury or death in an accident. To
reduce the risk of injury in an accident,
always make sure the head restraints are
installed and properly positioned when
the seat is occupied.
WARNING
l
Never place a cushion or similar device on
the seatback. This can adversely affect
head restraint performance by increasing
the distance between your head and the
restraint.
To adjust height
Adjust the head restraint height so that the
centre of the head restraint is as close as pos-
sible to eye level to reduce the chances of in-
jury in the event of collision. Any person too
tall for the head restraint to reach their seated
eye level, should adjust the restraint as high
as possible.
To raise the head restraint, move it upward.
To lower the restraint, move it downward
while pushing the height adjusting knob (A)
in the direction of the arrow. After adjust-
ment, push the head restraint downward and
make sure that it is locked.
To remove
To remove the head restraints, lift the head
restraint with the height adjusting knob (A)
pushed in.
Installation
To install the head restraints, first confirm
that they are facing the correct direction, and
then insert them into the seatback while
pressing the height adjusting knob (A) in the
direction indicated by the arrow.
CAUTION
l
Confirm that the height adjusting knob (A)
is correctly adjusted as shown in the illustra-
tion, and also lift the head restraints to en-
sure that they do not come out of the seat-
back.
Head restraints
4-07
OGAE15E5
Seat and seat belts
4
To Next Page
Loading...
Need help?
General
