Mitsubishi ASX 2016

Indication lamps
E00501600100
Turn-signal indication lamps/
Hazard warning indication
lamps
E00501700361
These indication lamps blink
in the following situations.
• When the turn-signal
lever is moved to ac-
tivate a turn-signal
lamp.
Refer to “Turn-signal
lever” on page 5-55.
• When the hazard
warning flasher
switch is pressed to
activate the hazard
warning lamps.
Refer to “Hazard
warning flasher
switch” on page
5-55.
• When the hazard
warning lamps auto-
matically activate due
to sudden braking
while driving.
Refer to “Emergency
stop signal system”
on page 6-48.
NOTE
l
If these indication lamps blink too fast due
to any operation other than sudden braking,
the cause may be a blown lamp bulb or a
faulty turn-signal connection.
High-beam indication lamp
E00501800173
This indication lamp illumi-
nates when the high-beam is
used.
Front fog lamp indication
lamp*
E00501900350
This lamp illuminates while
the front fog lamps are on.
Rear fog lamp indication lamp
E00502001326
This lamp illuminates while
the rear fog lamp is on.
Position lamp indication lamp
E00508900173
This indication lamp illumi-
nates while the position
lamps are on.
Diesel preheat indication lamp
(diesel-powered vehicles)
E00502300247
This indicates the glow plug
preheat condition.
[Except for vehicles equip-
ped with keyless operation
system]
When the ignition switch is
turned to the “ON” position, the lamp illumi-
nates. As the glow plug becomes hot, the
lamp goes out and the engine can be started.
[For vehicles equipped with keyless opera-
tion system]
When the operation mode is put in ON, the
lamp illuminates and preheating of the glow
lamp starts automatically. As the glow plug
becomes hot, the lamp goes out and the en-
gine starts.
Indication lamps
5-44
OGAE15E5
Instruments and controls
5