Mitsubishi ASX 2016

When you want to keep the
lamps on:
1. In the following cases, turn the lamp
switch to the “OFF” position.
[Except vehicles equipped with keyless
operation system]
The ignition switch is in the “LOCK” or
“ACC” position.
[For vehicles equipped with keyless op-
eration system]
The operation mode is in OFF or ACC.
2. Turn on the lamps with the switch in the
“
” or “ ” position again, then the
lamps will remain on.
NOTE
l
When the engine was started using the key,
if the driver’s door is opened and the key is
removed, the lamp monitor buzzer sounds at
a high pitch intermittently.
The buzzer stops when the driver’s door is
closed. (The warning is also displayed on the
multi-information display.)
The buzzer stops in the following manner.
•
Turn the lamp switch to the “OFF” posi-
tion.
•
Close the driver’s door.
l
When the engine was started using the key-
less operation function, if the driver’s door is
opened and the operation mode is put in
OFF, the lamp monitor buzzer sounds at a
high pitch intermittently.
NOTE
The buzzer stops when the driver’s door is
closed. (The warning is also displayed on the
multi-information display.)
The buzzer stops in the following manner.
•
Turn the lamp switch to the “OFF” posi-
tion.
•
Close the driver’s door.
Lamp monitor buzzer
E00506100559
[When the engine was started using the key]
If the driver’s door is opened when the key is
in the “LOCK” or “ACC” position or re-
moved from the ignition switch while the
lamps are on, a buzzer will sound to remind
the driver to turn off the lamps.
[When the engine was started using the key-
less operation function]
If the driver’s door is opened when the opera-
tion mode is in ACC or OFF with the lamps
illuminated, a buzzer will sound to remind
the driver to turn off the lamps.
In both cases, the buzzer will automatically
stop if the auto-cutoff function is activated,
the lamp switch is turned off, or the door is
closed.
Daytime running lamp*
E00530601079
The daytime running lamps come on when
the engine is running and the lamp switch is
in the “OFF” or “AUTO” position and the
tail lamps are off.
NOTE
l
If the lamp switch is in the “ ” or
“ ”position, or if the tail lamps are on
when the lamp switch is in the “AUTO” po-
sition, the daytime running lamps come on
as position lamps. (type 2 only).
1 - Daytime running lamp (type 1)
2 - Daytime running lamp (type 2)
Combination headlamps and dipper switch
5-51
OGAE15E5
Instruments and controls
5