NOTE
l
When the headlamps are turned off by the
automatic on/off control with the ignition
switch in the “ON” position, the front fog
lamps (if so equipped) and rear fog lamps al-
so go off. When the headlamps are subse-
quently turned back on by the automatic
on/off control, the front fog lamps also come
on but the rear fog lamp stays off. If you
wish to turn the rear fog lamp back on, oper-
ate the switch again.
l
Do not place anything on the automatic light
sensor (A), and do not clean with a glass
cleaner.
l
If the lamps do not turn on or off with the
switch in the “AUTO” position, manually
operate the switch and we recommend you
to have your vehicle checked.
Lamps (headlamps, fog lamp,
etc.) auto-cutout function
l
If the following operation is performed
while the lamp switch is in the “ ” po-
sition, the lamps will automatically go
out when the driver’s door is opened.
[Except vehicles equipped with keyless
operation system]
The ignition switch is turned to the
“LOCK” or “ACC” position, or the key
is removed from the ignition switch.
[For vehicles equipped with keyless op-
eration system]
The operation mode is in OFF or ACC.
[When the engine was started using the
key]
• If the key is removed and the driver’s
door is opened, a buzzer sounds at a
high pitch intermittently to remind the
driver to turn off the lamps.
[When the engine was started using the
keyless operation function]
• If the operation mode is put in OFF
and the driver’s door is opened, a buz-
zer sounds at a high pitch intermittent-
ly to remind the driver to turn off the
lamps.
l
If the following operation is performed
while the lamp switch is in the “ ” po-
sition, the lamps will remain on for
about 3 minutes while the driver’s door
is shut and will then automatically go
out.
[Except vehicles equipped with keyless
operation system]
The ignition switch is turned to the
“LOCK” or “ACC” position, or the key
is removed from the ignition switch.
[For vehicles equipped with keyless op-
eration system]
The operation mode is in OFF or ACC.
NOTE
l
The lamp auto-cutout will not function when
the lamp switch is in the “ ” position.
l
The lamp auto-cutout function can also be
disabled.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
Combination headlamps and dipper switch
5-50
OGAE15E5
Instruments and controls
5