If you press the multi-information meter
switch, the display screen switches to the
screen that was displayed before the warning
display and the mark (A) is displayed.
NOTE
l
Warning display screens with a “ ” or “ ”
mark displayed in the upper right of the
screen can be switched. If you want to
switch the display, press the multi-informa-
tion meter switch as follows.
“ ”: Press lightly.
“ ”: Press for about 2 seconds or more.
Redisplay of a warning display
screen
When the mark is displayed, if you lightly
press the multi-information meter switch a
few times, the warning display screen you
switched from is displayed again.
Other interrupt displays
The operation status of each system is dis-
played on the information screen.
Refer to the appropriate page in the warning
display list for further details.
Refer to “Other interrupt displays” on page
5-40.
Selector lever position display
screen*
E00532500323
Shows the position of the se-
lector lever.
Refer to “Selector lever op-
eration” on page 6-32.
Outside temperature display
screen
E00522100300
This shows the temperature
outside the vehicle.
NOTE
l
The display setting can be changed to the
preferred units (°C or °F).
Refer to “Changing the function settings
(when the ignition switch or the operation
mode is ON)” on page 5-19.
l
Depending on factors such as the driving
conditions, the displayed temperature may
vary from the actual outside temperature.
Fuel remaining display screen
E00522200402
This displays the amount of fuel remaining.
Multi-information display
5-15
OGAE15E5
Instruments and controls
5
To Next Page
Loading...
Need help?
General
