2. Press and hold the multi-information
meter switch for about 2 seconds or
more to display “ ” and make it flash.
(If there is no operation for about 10 sec-
onds with flashing, the display returns to
the previous screen.)
3. Lightly press the multi-information me-
ter switch while the icon is flashing to
change the display from “---” to
“CLEAR”. After this, the time until the
next periodic inspection will be dis-
played.
CAUTION
l
The customer is responsible for making sure
that periodic inspection and maintenance are
performed. Inspections and maintenance
must be performed to prevent accidents and
malfunctions.
NOTE
l
“---”display cannot be reset when the igni-
tion switch or the operation mode is in ON.
l
When “---” is displayed, after a certain dis-
tance and a certain period of time, the dis-
play is reset and the time until the next peri-
odic inspection is displayed.
l
If you accidentally reset the display, we rec-
ommend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
Door ajar warning display
screen (when the ignition
switch or the operation mode is
ON)
E00522600565
Type 1
Type 2
If any of the doors or the tailgate is not com-
pletely closed, this displays the open door or
tailgate.
If the vehicle speed exceeds approximately
8 km/h (5 mph) while a door is ajar, a buzzer
sounds 4 times. This notifies the driver that a
door is ajar.
CAUTION
l
Before moving your vehicle, check that the
warning lamp is OFF.
Multi-information display
5-18
OGAE15E5
Instruments and controls
5
To Next Page
Loading...
Need help?
General
