EasyManua.ls Logo

Mitsubishi ASX 2016

Mitsubishi ASX 2016
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To adjust intermittent intervals
With the lever in the “INT” (speed-sensitive)
position, the intermittent intervals can be ad-
justed by turning the knob (A).
1- Fast
2- Slow
NOTE
l
The speed-sensitive-operation function of
the windscreen wipers can be deactivated.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
Misting function
The misting function can be operated with
the ignition switch or the operation mode is
in ON or ACC.
The wipers will operate once if the wiper lev-
er is raised to the “MIST” position and re-
leased. This operation is useful when it is
drizzling, etc. The wipers will continue to op-
erate while the lever is held in the “MIST”
position.
Vehicles with rain sensor
E00517001555
The windscreen wipers can be operated with
the ignition switch or the operation mode is
in ON or ACC.
If the blades are frozen to the windscreen or
rear window, do not operate the wipers until
the ice has melted and the blades are freed,
otherwise the wiper motor may be damaged.
MIST- Misting function
The wipers will operate once.
OFF- Off
AU-
TO-
Auto-wiper control
Rain sensor
The wipers will automatically oper-
ate depending on the degree of wet-
ness on the windscreen.
LO- Slow
HI- Fast
Rain sensor
Can only be used when the ignition switch or
the operation mode is in ON.
Wiper and washer switch
5-58
OGAE15E5
Instruments and controls
5

Table of Contents

Related product manuals