EasyManua.ls Logo

Mitsubishi ASX 2016

Mitsubishi ASX 2016
452 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
l
An operation noise is emitted from the
engine compartment or you can feel a
shock from the brake pedal when start
driving immediately after starting the en-
gine. These are normal sounds or opera-
tions that the ABS makes when perform-
ing a self-check. It does not indicate a
malfunction.
l
The ABS can be used after the vehicle
has reached a speed over approximately
10 km/h (6 mph). It stops working when
the vehicle slows below approximately
5 km/h (3 mph).
CAUTION
l
The ABS cannot prevent accidents. It is your
responsibility to take safety precautions and
to drive carefully.
l
To prevent failure of the ABS, be sure all 4
wheels and tyres are the same size and the
same type.
l
Do not install any aftermarket limited-slip
differential (LSD) on your vehicle. The ABS
may stop functioning properly.
ABS warning lamp/display
E00607201135
Warning lamp
Warning display type 1
Warning display type 2
If there is a malfunction in the system, the
ABS warning lamp will come on and the
warning display will appear on the informa-
tion screen in the multi-information display.
Under normal conditions, the ABS warning
lamp only comes on when the ignition switch
is turned to the “ON” position or the opera-
tion mode is put in ON and goes off a few
seconds later.
CAUTION
l
Any of the following indicates that the ABS
is not functioning and only the standard
brake system is working. (The standard
brake system is functioning normally.) If
this happens, we recommend you to have
your vehicle inspected as soon as possible.
When the ignition switch is turned to the
“ON” position or the operation mode is
put in ON, the warning lamp does not
come on or it remains on and does not go
off.
The warning lamp comes on while driv-
ing.
The warning display appears while driv-
ing.
If the warning lamp/display il-
luminate while driving
E00607301295
If only the ABS warning lamp/
display illuminate
Avoid hard braking and high-speed driving.
Stop the vehicle in a safe place.
Restart the engine and check to see whether
the lamp goes out after a few minutes driv-
ing; if it then remains off during driving,
there is no problem.
However, if the warning lamp/display do not
disappear, or if they come on again when the
vehicle is driven, we recommend you to have
the vehicle checked.
Anti-lock brake system (ABS)
6-49
OGAE15E5
Starting and driving
6

Table of Contents

Related product manuals