3. While holding down the tab (D), pull out
the socket (E).
4. Turn the bulb (F) anticlockwise to re-
move it.
5. To install the bulb, perform the removal
steps in reverse.
CAUTION
l
Handle halogen lamp bulbs with care. The
gas inside halogen lamp bulbs is highly pres-
surized, so dropping, knocking, or scratching
a halogen lamp bulb can cause it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the fog lamps are op-
erated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc., and
refit it after drying it thoroughly.
Daytime running lamps (type
2)*/Position lamps (type 2)*
E01012000021
NOTE
l
An LED, not a bulb, is used in the daytime
running lamp (type 2) / position lamp (type
2). Contact a MITSUBISHI MOTORS Au-
thorized Service Point when there is a need
for repair or replacement.
Daytime running lamps (type
1)*
E01011201137
1. Insert a straight blade (or minus) screw-
driver with a cloth over its tip into the
daytime running lamp cover (A) and pry
gently to remove it.
Replacement of lamp bulbs
10-33
OGAE15E5
Maintenance
10
To Next Page
Loading...
