Raise or lower the seat belt anchor (A) while
pressing the lock knob (B).
WARNING
l
When adjusting the seat belt anchor, set it
at a position that is sufficiently high so
that the belt will make full contact with
your shoulder but will not touch your
neck.
3-point type seat belt with 2
buckles
E00414700117
3-point type seat belt with 2 buckles is fitted
in the rear centre seating position.
NOTE
l
You can check if the belt locks by pulling it
forward quickly.
To fasten
1. Pull the seat belt out slowly and pass it
through the seat belt guide (A).
NOTE
l
When the seat belts cannot be pulled out in a
locked condition, pull the belt once forceful-
ly and then return it.
After that, pull the belt out slowly once
again.
2. After making sure that the seat belt is
not twisted, insert the latch plate (B) into
the buckle (C) aligning the marks (D) on
the plate and buckle until a “click” is
heard.
WARNING
l
When using the seat belt, make sure to se-
curely connect the latch plate (B) with the
buckle (C). Failing to do so could signifi-
cantly reduce the amount of protection
and cause serious injures in a collision or
a sudden stop.
Seat belts
4-12
OGAE15E5
Seat and seat belts
4
To Next Page
Loading...
