Troubleshooting (cont.)
Problems Possible Solutions
For More Information
The remote control doesn't
work.
Check that the batteries are
installed correctly.
Check that the select switch
is set to "TV."
Be sure that you are
pointing the tip of the
remote control toward the
TV from a distance of no
more than 20 feet.
See "Getring ready to use
the remote control" in
Chapter 1 for an explanation
of how to install batteries.
See "Remote control buttons
and functions" in Chapter 1,
which explains where the
select switch is located.
See "Getting ready to use
the remote control" in
Chapter 1, which contains
pointers for using the remote
contrd.
• The TV takes several
seconds to respond to button
commands.
• Use the ENTER button to
avoid delays.
See "Changing channels" in
Chapter 3, which explains
the function of the ENTER
button.
You can't access a channel. • Be sure that the channel you
want to view is programmed
into memory.
See "Memorizing channels"
in Chapter 3, which ,explains
how to program channels
into the TV's memory.
• Check that the TV is tuned
to the correct input source
(antenna) for that channel.
See "Selecting the input
source" in Chapter 3, which
explains how to change the
input source.
You can't see a different
channel in the reduced PIP
image.
• Use the PIP INPUT button
to change the source of the
PIP image.
• See "Using the Picture-in-
Picture (PIP) Modes" in
Chapter 4.
Make sure you have a
second source, such as a
VCR, turned on and con-
nected to your TV.
PIP image is distorted or is
not in color.
• Cycle through PIP sources
by pressing PIP INPUT
repeatedly.
• See "U,_ing the Picture-in-
Pict_.re (PIP) Modes," in
Chapter 4.
92 Chapter 5: Troubleshooting
To Next Page
Loading...
Need help?
General
