Screen Cause Solution (Reference)
l
The Electric parking brake is not automat-
ically applied because there is a fault in
the Electric parking brake system.
l
When the ignition switch is turned off or
the operation mode is put in OFF, place
the selector lever in the “P” (Park) posi-
tion and depress the brake pedal more
firmly than usual with the right foot.
Then, operate the ignition switch or the
engine switch.
l
We recommend you to have the brake au-
to hold system inspected by a
MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Brake auto hold” on page 6-44.
l
The brake auto hold system does not turn
on because the driver’s seat belt is not fas-
tened.
l
Press the brake auto hold switch after fas-
tening the driver’s seat belt.
Refer to “Brake auto hold” on page 6-44.
l
The brake auto hold system does not turn
off because the brake pedal is not pressed.
l
Depress the brake pedal more firmly than
usual with the right foot. Then, press the
brake auto hold switch.
Refer to “Brake auto hold” on page 6-44.
l
There is a fault in the engine oil circula-
tion system.
l
Immediately stop the vehicle in a safe
place. We recommend you to have it
checked.
Refer to “Oil pressure warning display”
on page 5-49
Indication lamp, warning lamp, and information screen display list
5-31
OGKE18E1
Instruments and controls
5
To Next Page
Loading...
