NOTE
l
The driver’s door cannot be locked using the
inside lock knob while the driver’s door is
opened.
Central door locks
E00300803423
NOTE
l
Repeated continuous operation between lock
and unlock could activate the central door
locking systems built-in protection circuit
and prevent the system from operating. If
this occurs, wait approximately 1 minute be-
fore operating the central door lock switch.
l
When the driver’s door is open, the central
door lock switch cannot be used to lock it.
To lock and unlock the doors
and tailgate
Using the central door lock
switch
Using the central door lock switch on the
driver’s door locks or unlocks all doors and
the tailgate.
1- Lock
2- Unlock
To unlock the doors and tail-
gate
E00311301381
You can select the functions to unlock the
doors and tailgate either using the ignition
switch or the engine switch, or using the se-
lector lever position.
These functions are not activated when the
vehicle is shipped from the factory. To acti-
vate or deactivate these functions, please con-
tact a MITSUBISHI MOTORS Authorized
Service Point.
Using the ignition switch or the
engine switch
All doors and the tailgate will unlock when-
ever the ignition switch is turned to the
“LOCK” position or the operation mode is
put in OFF.
Using the selector lever position
All doors and the tailgate will unlock when-
ever the selector lever is moved to the “P”
(PARK) position with the ignition switch in
the “ON” position or put the operation mode
in ON.
Central door locks
3-18
OGKE18E1
Locking and unlocking
3
To Next Page
Loading...
Need help?
General
