When there is a malfunction in
the sensor or the system
E00644000094
Example: When there is a malfunction in
both sensors
When the warning display appears, the UMS
does not operate normally because there are
some malfunctions in the system. Have the
vehicle inspected at a MITSUBISHI
MOTORS Authorized Service Point as soon
as possible.
Blind Spot Warning (BSW)
(with Lane Change Assist)*
E00644300130
The Blind Spot Warning (BSW) is a driving
aid system that alerts the driver when another
vehicle, which may not be visible through the
outside rear-view mirror, is travelling in the
next lane behind your vehicle.
When a vehicle in the next lane is travelling
at the same speed or faster in the detection
areas, the Blind Spot Warning lamp in the
corresponding outside rear-view mirror will
illuminate. If the turn-signal lever is operated
to the side where the Blind Spot Warning
lamp is illuminated, the Blind Spot Warning
lamp will blink and the system will beep
three times to alert the driver.
Depending on the speed of your vehicle, the
BSW system will detect up to approximately
70 m from your vehicle.
WARNING
l
Before using the BSW, read this entire
section to fully understand the limitations
of this system. Failure to follow instruc-
tions could result in an accident.
WARNING
l
Never rely solely on the BSW system
when changing lanes. The BSW is an aid
only. It is not a substitute for your safe
and careful driving. Always check visually
behind and all around your vehicle for
other vehicles.
The performance of the BSW may vary
depending on driving, traffic and/or road
conditions.
Detection areas
E00644400173
The BSW uses two sensors (A) located inside
the rear bumper.
The detection areas are shown as illustrated.
Blind Spot Warning (BSW) (with Lane Change Assist)*
6-95
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
