Mitsubishi ECLIPSE CROSS 2017 User Manual

AUTO
With the ignition switch or the
operation mode in ON, the
headlamps, position, tail, licence
plate and instrument panel
lamps turn on and off automati-
cally in accordance with outside
light level.
{Daytime running lamps will go
on while the tail lamps are off.}
All lamps turn off automatically
when the ignition switch is
turned to “LOCK” position or
the operation mode is put in
OFF.
Position, tail, licence plate and
instrument panel lamps on
Headlamps and other lamps go
on
NOTE
l
When the headlamps are turned off by the
automatic on/off control with the ignition
switch in the “ON” position or the operation
mode in ON, the front fog lamp (if so equip-
ped) and rear fog lamps also go off. When
the headlamps are subsequently turned back
on by the automatic on/off control, the front
fog lamps also come on but the rear fog
lamp stays off. If you wish to turn the rear
fog lamp back on, operate the switch again.
NOTE
l
Do not cover the sensor (A) for the automat-
ic on/off control by affixing a sticker or label
to the windscreen.
l
If the lamps do not turn on or off with the
switch in the “AUTO” position, manually
operate the switch and we recommend you
to have your vehicle checked.
Lamps (headlamps, fog lamps,
etc.) auto-cutout function
E00532701713
l
If the following operation is performed
while the lamp switch is in the “ ” po-
sition, the lamps will turn off automati-
cally when the driver’s door is opened.
[Except for vehicles equipped with key-
less operation system]
The ignition switch is turned to the
“LOCK” or “ACC” position, or the key
is removed from the ignition switch.
[For vehicles equipped with keyless op-
eration system]
The operation mode is in OFF or ACC.
l
If the following operation is performed
while the lamp switch is in the “ ” po-
sition, the lamps will remain on for ap-
proximately 3 minutes while the driver’s
door is shut and will then automatically
turn off.
[Except for vehicles equipped with key-
less operation system]
The ignition switch is turned to the
“LOCK” or “ACC” position, or the key
is removed from the ignition switch.
[For vehicles equipped with keyless op-
eration system]
The operation mode is in OFF or ACC.
Combination headlamps and dipper switch
5-56
OGKE18E1
Instruments and controls
5

Mitsubishi ECLIPSE CROSS 2017 Specifications

General

Brand	Mitsubishi
Model	ECLIPSE CROSS 2017
Category	Automobile
Language	English