Mitsubishi ECLIPSE CROSS 2017 User Manual

2. Press the AHB switch.
The AHB is activated and the indicator
will illuminate.
If the AHB switch is pressed again, the
AHB will be deactivated and AHB indi-
cator will go off.
NOTE
l
You can switch the headlamp beams (high/
low) manually by operating the lever even if
the AHB is working.
Refer to “Dipper (High/Low beam change)”
on page 5-58
If the lever is operated manually, the AHB
indicator will go off and the AHB will be
deactivated.
Refer to “Manual switching” on page 5-58.
l
The AHB is not deactivated when you pull
the lever slightly (operation of the headlamp
flasher).
Manual switching
Switching to low beam
1. Pull the turn-signal lever towards you.
2. The AHB indicator will go off.
3. The AHB switch is pressed again, the
AHB will activated.
Switching to high-beam
1. Pull the turn-signal lever towards you.
2. The AHB indicator will go off and the
high-beam indicator illuminates.
3. The AHB switch is pressed again, the
AHB will activated.
Automatic switching conditions
E00551600062
The high-beam headlamps illuminate when
all of the following conditions are met:
l
Your vehicle speed exceeds approxi-
mately 40 km/h (25 mph).
l
It is dark ahead of your vehicle.
l
There are no vehicles in front or oncom-
ing vehicles, or none of their exterior
lamps are illuminated.
The low beam headlamps illuminate when
any of the following conditions occur:
l
Your vehicle speed does not exceed ap-
proximately 30 km/h (19 mph).
l
It is bright ahead of your vehicle.
l
An exterior lamp of a vehicle in front or
oncoming vehicle is illuminating.
NOTE
l
The headlamps may not be switched from
high-beam to low beam under the following
circumstances.
•
A vehicle in front or oncoming vehicle is
hindered by any object such as continuous
bends, elevated median/island, traffic
signs, roadside trees.
•
Your vehicle passes an oncoming vehicle
suddenly on a bend with poor visibility.
•
Another vehicle crosses ahead of your ve-
hicle.
l
The headlamps may remain at low beam (or
be switched from high-beam to low beam)
when a reflective object (e.g. street lamp,
traffic signal, noticeboard and signboard) re-
flects light.
l
Any of the following factors may influence
the headlamp beam switching timing:
Combination headlamps and dipper switch
5-59
OGKE18E1
Instruments and controls
5

Mitsubishi ECLIPSE CROSS 2017 Specifications

General

Brand	Mitsubishi
Model	ECLIPSE CROSS 2017
Category	Automobile
Language	English