CAUTION
•
When the air conditioner is operated in
automatic mode where the temperature
control is set to the max. hot or the max.
cool
•
When the air conditioner is ON, the pas-
senger compartment temperature rises and
the air conditioning compressor operates
to lower the temperature
•
Demister switch is pressed
Refer to “Demisting of the windscreen
and door windows” on page 7-07.
•
Electric power consumption is high, such
as when the rear window demister or oth-
er electrical components are operating or
the blower speed is set to a high setting.
•
Push the accelerator pedal (CVT)
•
Battery voltage or battery performance is
low
•
Operate the steering wheel
•
After the engine stop, 3 minute elapse
(CVT)
•
Move the selector lever to the “R” (RE-
VERSE) position (CVT)
•
Move the selector lever from the “N”
(NEUTRAL) to “D” (DRIVE) position
(CVT)
•
Driver’s seat belt is unfastened
•
Driver’s door is opened
•
When the Electric parking brake switch is
pulled up to operate the Electric parking
brake (on vehicles equipped with the
Electric parking brake).
NOTE
l
In the following cases, the engine will not
restart automatically.
•
Bonnet is open
•
On vehicles equipped with M/T, while the
engine is stopped automatically, “Auto
Stop & Go (AS&G) OFF” switch is press-
ed to deactivate the “Auto Stop & Go
(AS&G) OFF” system.
l
When the engine restarts automatically, the
audio volume may temporarily decrease.
This does not indicate a malfunction.
l
While the engine is stopped automatically,
the air volume change of the air conditioner
may temporarily be experienced. This does
not indicate a malfunction.
l
On vehicles equipped with CVT, while the
engine is stopped automatically, if the selec-
tor lever is moved to the “P” (PARK) posi-
tion quickly with the brake pedal firmly de-
pressed, the engine does not restart automat-
ically even if you release the brake pedal.
If this occurs, the display will blink to
inform the driver.
If you want to restart the engine, depress the
brake pedal again.
If you want to put the operation mode in
OFF, press the engine switch without de-
pressing the brake pedal. (on vehicles equip-
ped with the keyless operation system)
To deactivate
E00627701178
The AS&G system is automatically activated
when the ignition switch is turned to the
“ON” position or the operation mode put in
ON. You can deactivate the system by press-
ing the “Auto Stop & Go (AS&G) OFF”
switch.
When the AS&G system is deactivated, the
display will be turned on.
To reactivate the AS&G system, press the
“Auto Stop & Go (AS&G) OFF” switch; the
display will turn off.
AS&G OFF indicator display
Auto Stop & Go (AS&G) system
6-28
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
