Mitsubishi ECLIPSE CROSS 2017 User Manual

NOTE
l
If you keep pressing the brake auto hold
switch after setting the brake auto hold to
ON (Stand by), the brake auto hold will re-
turn to OFF as a protection function is oper-
ated.
After returning to OFF, the brake auto hold
will not be switched to ON (stand by) even
if the brake auto hold switch is pressed. To
set the brake auto hold to ON, restart the en-
gine and press the brake auto hold switch
again.
To activate brake auto hold
When the vehicle is stopped by depressing
the brake pedal with the selector lever in any
position other than “P” (Park) or “R” (Re-
verse), the brake auto hold activates and the
vehicle will be held stationary.
The brake auto hold indication lamp in the
instrument cluster will come on while the
system activates.
CAUTION
l
Release the brake pedal after the brake auto
hold indication lamp is illuminated.
NOTE
l
In the following situations, the brake auto
hold system may not operate temporarily.
•
The vehicle is stopped on a slippery road.
•
The vehicle was stopped while the steer-
ing wheel was turned all the way to the
left or right.
•
The vehicle is being turned on a parking
lot turntable.
If this occurs, the brake auto hold system
will return to the normal operation if you de-
NOTE
press the accelerator pedal and the vehicle
starts moving again.
l
If the following operation is performed, the
brake auto hold will be deactivated and the
brake auto hold indication lamp in the in-
strument cluster goes off.
•
When shifting the selector lever to the “P”
(Park) or “R” (Reverse) position with de-
pressing the brake pedal.
•
When the Electric parking brake is ap-
plied by using the Electric parking brake
switch.
l
While the vehicle is held stationary with the
brake auto hold system, the Electric parking
brake will be automatically applied under
the following conditions, and a buzzer will
sound and the message will appear on the in-
formation screen in the multi-information
display.
•
After approximately 10 minutes have
elapsed while applying the brake auto
hold system.
•
When the driver’s seat belt is unfastened.
•
When the driver’s door is opened.
•
When the ignition switch is turned to the
“LOCK” position or the operation mode
is put in OFF.
Brake auto hold*
6-46
OGKE18E1
Starting and driving
6

Mitsubishi ECLIPSE CROSS 2017 Specifications

General

Brand	Mitsubishi
Model	ECLIPSE CROSS 2017
Category	Automobile
Language	English