To temporarily accelerate the
vehicle
Simply depress the accelerator pedal to tem-
porarily accelerate the vehicle. Release the
pedal to restart the ACC control.
CAUTION
l
The ACC braking control and proximity
alarm functions will not work while the ac-
celerator pedal is depressed.
l
The setting speed should be set up the suita-
ble speed according to a situation.
NOTE
l
The set speed indication on the display turns
to “---” when the accelerator pedal is de-
pressed. This indication remains as long as
the pedal is in a depressed position.
NOTE
l
In certain conditions, the braking control and
alarming functions of the ACC may not
work for a short while after releasing the ac-
celerator pedal.
l
Set speed adjustment is impossible while the
accelerator pedal is in a depressed position.
To terminate ACC control
E00638200176
To cancel of ACC control
You can cancel the ACC control by using ei-
ther of the methods below.
When the control is cancelled, the system is
placed in the standby state. You can make the
system restart the control by using the
“SET -” or “RES +” switch if the conditions
for activating the control are met.
l
Press the “CANCEL” switch.
l
Depress the brake pedal (except for the
stationary vehicle hold state).
NOTE
l
You can also cancel the ACC control by
pressing the ACC ON/OFF switch. If this
switch is pressed, the ACC is turned off.
l
If you press the “CANCEL” switch or “ACC
ON/OFF” switch to cancel the stationary ve-
hicle hold state, the vehicle will start creep-
ing.
When the system shifts into the standby state
as a result of cancellation of the ACC control,
the “SET” indicator goes out. At the same
time, the display of the following distance
setting and running-ahead vehicle symbol
(only when the ACC is detecting a vehicle) is
placed in the standby state of display.
Adaptive Cruise Control System (ACC)*
6-74
OGKE18E1
Starting and driving
6
To Next Page
Loading...
