EasyManuals Logo

Mitsubishi ECLIPSE CROSS 2017 User Manual

Mitsubishi ECLIPSE CROSS 2017
538 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #271 background imageLoading...
Page #271 background image
To operate
E00652300171
When the ignition switch is turned to the
“ON” position or the operation mode is put in
ON and “ON” is selected in the “BSW” set-
ting screen, the Blind Spot Warning (BSW)
indication lamp in the instrument cluster
comes on and the BSW enters the standby
state.
When “OFF” is selected in the “BSW” set-
ting screen, the Blind Spot Warning (BSW)
indication lamp in the instrument cluster goes
off and the BSW turns off.
To turn the BSW ON/OFF, follow the proce-
dure below.
1. Switch to the function setting screen.
Refer to “Multi-information display
switches” on page 5-04
Refer to “Changing the function set-
tings” on page 5-13
2. Press the
switch or switch several
times to switch to the “BSW” screen.
Then, press the switch to switch to en-
ter the setting selection screen.
3. Press the
switch or switch to select
the “ON” or “OFF”, and then press the
switch to confirm the setting.
Indication lamp
If you turn the BSW ON/OFF, the Rear Cross
Traffic Alert (RCTA) also turns ON/OFF at
the same time.
NOTE
l
When the ignition switch is turned to the
“LOCK” position or the operation mode is
set to OFF, the selected condition just before
setting to OFF is retained.
l
The BSW operates when all of the following
conditions are met.
The ignition switch is turned to the “ON”
position or the operation mode is put in
ON.
The selector lever is in positions other
than “P” (Park) and “R” (Reverse).
NOTE
The speed of your vehicle is approximate-
ly 10 km/h (6 mph) or higher.
When the sensor detects an ap-
proaching vehicle
When the Blind Spot Warning (BSW) indica-
tion lamp in the instrument cluster is on, if a
vehicle is approaching your vehicle in the de-
tection area, the Blind Spot Warning lamp in
the outside rear-view mirror illuminates.
If the turn-signal lever is operated to the side
where the Blind Spot Warning lamp is illumi-
nated, the Blind Spot Warning lamp will
blink and the system will beep three times to
alert the driver.
Blind Spot Warning (BSW) (with Lane Change Assist)*
6-97
OGKE18E1
Starting and driving
6

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi ECLIPSE CROSS 2017 and is the answer not in the manual?

Mitsubishi ECLIPSE CROSS 2017 Specifications

General IconGeneral
BrandMitsubishi
ModelECLIPSE CROSS 2017
CategoryAutomobile
LanguageEnglish

Related product manuals