The system automatically shifts from the
“ON” state to the standby state if all of the
following conditions are simultaneously met.
The indicator on the information screen in
the multi-information display will be changed
from white to green.
l
The vehicle speed is approximately
65 km/h (40 mph) or higher.
l
The turn-signal lever is not operated.
l
The hazard lamp is not activated.
l
Environmental conditions are adequate
for the system to recognize the lane
markings on both sides.
l
The system has been placed in the “ON”
state.
NOTE
l
The system stays in the “ON” state for ap-
proximately 7 seconds after the hazard lamp
has stopped flashing or the turn-signal lever
has returned to the home position.
Lane departure warning
E00638600079
A buzzer sounds intermittently and the indi-
cation of “LANE DEPARTURE” appears on
the information screen of the multi-informa-
tion display,
and the indicator starts flash-
ing in yellow when your vehicle is about to
leave or has left the lane in the standby mode.
NOTE
l
If the warning continues for approximately 3
seconds or more, the system switches to the
standby mode before the warning stops.
NOTE
l
If the lane markers are only on one side of
the road, the LDW will operate only for the
appropriate side where the lane marker is
drawn.
System problem warning
E00635901049
If there is a malfunction in the system, a
warning will appear on the information
screen of the multi-information display de-
pending on the situation.
Too hot or cold sensor
E00638700067
The alarm shown below is displayed if the
system becomes temporarily unavailable due
to a too high or low temperature of the sen-
sor.
If the temperature of the sensor reaches the
predetermined value, the system automatical-
ly recovers the normal state.
If the alarm continues showing, there is a
possibility that the LDW has a malfunction.
Contact a MITSUBISHI MOTORS Author-
ized Service Point for inspection of the sys-
tem.
Lane Departure Warning (LDW)*
6-102
OGKE18E1
Starting and driving
6