WARNING
l
The spare tyre with a speed limit label
does not have a tyre inflation pressure
sensor.
When the spare tyre with a speed limit la-
bel is used, the TPMS will not work prop-
erly. See an MITSUBISHI MOTORS Au-
thorized Service Point as soon as possible
to replace or repair the original tyre.
NOTE
l
The TPMS is not a substitute for regularly
checking tyre inflation pressures.
Be sure to check the tyre inflation pressures
as described in “Tyres” on page 10-10.
l
The tyre inflation pressure sensor (B) is in-
stalled in the illustrated location.
•
On vehicles equipped with the Type 1
sensor which has the metallic air valve
(C), replace grommet and washer (D)
with the new ones when the tyre is re-
placed.
•
On vehicles equipped with the Type 2
sensor which has the rubber air valve (E),
replace rubber air valve (E) with new one
when the tyre is replaced.
For details, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
NOTE
l
The spare tyre with aluminium wheel has the
tyre inflation pressure sensor, so it can be
used for tyre rotation.
TPMS warning lamp/display
E00637200225
When the ignition switch is turned to the
“ON” position or the operation mode is put in
ON, the TPMS warning lamp normally illu-
minates and goes off a few seconds later.
If one or more of the vehicle tyres are signifi-
cantly under-inflated, the warning lamp will
remain illuminated while the ignition switch
or the operation mode is in ON.
Refer to “If the warning lamp/display illumi-
nates while driving” on page 6-107 and take
the necessary measures.
NOTE
l
The TPMS does not monitor the spare tyre
in the tyre hanger, even if the inflation pres-
sure sensor is equipped.
l
The warning display is displayed on the in-
formation screen in the multi-information
display.
Tyre pressure monitoring system (TPMS)*
6-105
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
