CAUTION
l
The parking sensors may not operate proper-
ly under the following conditions:
•
The sensors or surroundings have been
wiped by hand.
•
The stickers or accessories have been at-
tached to the sensors or surroundings.
•
The sensors or surroundings are covered
with ice, snow, or mud.
•
When the temperature difference is too
large.
•
The sensors are frozen.
•
The system receives ultrasonic noise from
other sources (the horns of other vehicles,
motorcycle engines, brakes, radios, pour-
ing rain, splashing water, snow traction
device (tyre chains), etc.).
•
The sensors are extremely hot or cold
(while the vehicle is parked for a long pe-
riod of time under a blazing sun or in cold
weather).
•
The vehicle tilts significantly.
•
The vehicle is driven on a rough road
(with a bumpy, gravel, hilly, or grassy
surface).
•
The vehicle is too close to an obstacle.
•
Immediately after engine starting.
l
The parking sensors may not properly detect
the followings:
•
Objects that are thin, such as wire nets or
ropes.
•
Objects that absorb sound waves, such as
snow.
•
Objects that are shaped with a sharp an-
gle.
CAUTION
•
Objects with a smooth surface, such as
glass.
•
Objects that are low, such as kerbstones.
l
If the bumper has been exposed to an im-
pact, the sensors may fail and prevent the
system from functioning properly. Have the
vehicle inspected at a MITSUBISHI
MOTORS Authorized Service Point.
NOTE
l
When the sensor is received ultrasonic noise
from outside, the sensor of the correspond-
ing portion will blink at a constant frequen-
cy. When they are not received the noise and
return to normal operation.
To operate
E00648100181
To operate the system, the operation mode is
put in ON. When the parking sensors are op-
erated, the indication lamp (A) will turn on.
To stop the operation, press the “SONAR”
switch and the indication lamp (A) goes off.
Parking sensors (Front/Rear)*
6-111
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
