Mode Message Cause Response
VER ERROR This iPod/iPhone software version is not supported. Please change to a supported software version.
Other ERROR DC An abnormal direct voltage has been sent to the speak-
ers.
Turn the power OFF and wait a short while. If the
problem persists, consult a MITSUBISHI MOTORS
Authorized Service Point.
If You Think Something Is Not Working Properly...
Here is a list of symptoms, causes and responses if you think something is not working properly.
Symptoms Cause Response
There is no sound or quiet
sound.
The volume is turned to its minimum. Adjusting the volume.
→ “Adjusting the Volume” on page 7-32.
The balance or fader is turned to one side. Adjusting the balance or fader.
→ “Adjust Audio Quality and Volume Balance” on
page 7-50.
The disc cannot be inserted.
A disc is already in the product. Eject the disc.
→ “Insert/Eject Discs” on page 7-32.
There is no disc in the product, but the product says it is
loading.
Press the eject button once.
→ “Insert/Eject Discs” on page 7-32.
The disc cannot be played.
The disc is inserted upside down. Insert with the label side up.
The disc has condensation on it. Wait a while before inserting.
The disc is dirty. Clean the read surface of the disc.
The sound skips in the
same place.
The disc is damaged or dirty. Check the disc.
There is no sound, even if
the disc is inserted.
Damage to or dirt on the disc means that its data cannot
be read.
Check the disc. Additionally, if using CD-R/RW discs,
their characteristics may render them unable to be
played.
Troubleshooting
7-56
OGKE18E1
For pleasant driving
7
To Next Page
Loading...
Need help?
General
