NOTE
•
The tyre has completely slipped over the
wheel rim and has come off the wheel.
•
The wheel is damaged.
l
Use the tyre sealant only at ambient temper-
atures of -30 °C to +60 °C.
l
Effect an emergency repair without pulling
out the object (nail, screw, etc.) that is stuck
in the tyre.
l
Do not use the tyre sealant if the tyre has
been damaged by being driven when insuffi-
ciently inflated (e.g. bumps, cuts, cracks etc.
on the tyre).
l
Wipe tyre sealant off the paintwork immedi-
ately with a damp cloth.
l
Immediately wash clothes contaminated
with tyre sealant.
l
Check the tyre sealant’s expiry date regular-
ly, be sure to purchase a new one from a
MITSUBISHI MOTORS Authorized Serv-
ice Point before the expiry date.
Before repairing a tyre, first stop your vehicle
in a safe, flat location.
1. Park the vehicle on level and stable
ground.
2. Set the parking brake firmly.
3. On vehicles with M/T, stop the engine
and move the gearshift lever to the “R”
(Reverse) position.
On vehicles with CVT, move the selec-
tor lever to the “P” (PARK) position and
stop the engine.
4. Turn on the hazard warning flashers and
set up a warning triangle, flashing signal
lamp, etc., at an adequate distance from
the vehicle, and have all your passengers
leave the vehicle.
5. Take out the tyre repair kit.
6. Take the valve cap (C) off the tyre valve
(D), then press the valve remover (E)
onto the valve as illustrated. Allow all of
the air in the tyre to escape.
7. Remove the valve insert (F) by turning it
anticlockwise using the valve remover
(E). Put the removed valve insert in a
clean place so it does not get dirty.
CAUTION
l
If there is any air left in the tyre when you
remove the valve insert, the valve insert may
fly out and injure you. Make sure the tyre
contains no air before removing the valve in-
sert.
8. Shake the tyre sealant bottle well.
Tyre repair kit*
8-08
OGKE18E1
For emergencies
8
To Next Page
Loading...
Need help?
General
