1- Open (rear shade)
2. Close (rear shade)
Opening the rear shade
Press the switch in direction (7) to fully open
the rear shade automatically.
To stop the shade before it is fully open,
press the switch in direction (7) or (8).
Closing the rear shade
Press the switch in direction (8) to fully close
the rear shade automatically.
To stop the shade before it is fully closed,
press the switch in direction (7) or (8).
Safety mechanism
If a person’s hand, neck, etc., is trapped in
the rear shade, the shade will automatically
open a maximum of 20 cm as a safety func-
tion. After the rear shade opens, you can use
the switch to close it.
If the safety mechanism operates five times
or more consecutively, you will not be able to
close the rear shade normally.
If this occurs, perform the following proce-
dure to reset the safety mechanism.
1. Press and hold the switch in direction
(8).
2. The rear shade will move to the fully
closed position in small increments.
3. When the rear shade has stopped in the
fully closed position, release the switch.
(The resetting procedure is finished.)
If the rear shade does not move correctly to
the fully closed position after you perform
the resetting procedure, contact a
MITSUBISHI MOTORS Authorized Service
Point.
CAUTION
l
The safety mechanism is cancelled just be-
fore the rear shade is fully closed. This al-
lows the rear shade to close completely.
Therefore be especially careful that no fin-
gers are trapped in the rear shade.
NOTE
l
The safety mechanism can be activated if the
driving conditions or other circumstances
cause the rear shade to be subjected to a
physical shock similar to that caused by a
trapped hand or head.
l
Do not release the switch until the resetting
procedure is finished. If you release the
switch, the resetting mode will be cancelled.
To perform the resetting procedure again, re-
peat the procedure from step 1.
Power panoramic sunroof*
3-35
OGKE18E1
Locking and unlocking
3
To Next Page
Loading...
