Headlamps (high-beam, except for ve-
hicles with high intensity discharge
headlamps)
E01009400164
1. When
replacing the bulb on the right side of
the vehicle, remove the bolt (A) holding
down the washer tank spout and move the
spout towards the rear of the vehicle.
*: Front of the vehicle
2.
Turn the cap (B) anticlockwise to remove it.
*: Front of the vehicle
3. Turn the bulb (C) anticlockwise to remove it.
*: Front of the vehicle
4. While
pressing the tab (D), pull out the bulb
(E).
5. To
install the bulb, perform the removal
steps in reverse.
CAUTION
l
Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc. The oil from
your hand could cause the bulb to break
the next time the headlamps are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
Headlamps (high/low beam, for vehi-
cles
with high intensity discharge head-
lamps)
E01003501203
Do not attempt to disassemble or repair headlamps,
and do not attempt to replace their bulbs.
Maintenance
8-31
8
To Next Page
Loading...
