WARNING
l
A high voltage is present in the power cir-
cuit and in the bulbs and bulb terminals.
To avoid the risk of an electric shock, con-
tact a MITSUBISHI MOTORS Author-
ized Service Point whenever repair or re-
placement is necessary.
Bending lamps (Adaptive Front light-
ing System (AFS)) (for vehicles equip-
ped
with high intensity discharge head-
lamps)
E01008800217
1. When
replacing the bulb on the right side of
the vehicle, remove the bolt (A) holding
down the washer tank spout and move the
spout towards the rear of the vehicle.
*: Front of the vehicle
2. Turn the cap (B) anticlockwise to remove it.
*: Front of the vehicle
3. Turn the bulb (C) anticlockwise to remove it.
*: Front of the vehicle
4. While pressing the tab (D), pull out the bulb
(E).
5. To
install the bulb, perform the removal
steps in reverse.
CAUTION
l
Handle
halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc. The oil from
your hand could cause the bulb to break
the next time the bending lamps (Adap-
tive Front lighting System (AFS)) are op-
erated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
Maintenance
8-32
8
To Next Page
Loading...
