3. Remove the bulb by pulling it out.
4. To
install the bulb, perform the removal
steps in reverse.
Front fog lamps (Type 1)*
E01004001120
1. Remove
the screw (A) and pull the cover out.
2. Remove
the screws (B) and pull the entire
lamp unit out.
NOTE
l
When
unfastening the screws, be careful not
to mistakenly move the beam position adjust-
ment screw (C).
3. Push the connector (D) to disconnect and re-
move the fog lamp.
4. Remove
the bulb assembly (E) by turning it
anticlockwise.
CAUTION
l
Handle
halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
Maintenance
8-36
8
To Next Page
Loading...
