CAUTION
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the fog lamps
are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
5. To
install the bulb, perform the removal
steps in reverse.
NOTE
l
When
mounting the cover, align the hooks
(F) on the cover with the hole in the body.
Front fog lamps (Type 2)*
E01004001133
1. Remove the screw (A).
2. Pull the cover out in the direction of the ar-
row shown in the illustration.
3. Remove
the screws (B) and pull the entire
lamp unit out.
NOTE
l
When
unfastening the screws, be careful not
to mistakenly move the beam position adjust-
ment screw (C).
Maintenance
8-37
8
To Next Page
Loading...
