4. Push
the connector (D) to disconnect and re-
move the fog lamp.
5. Remove the bulb assembly (E) by turning it
anticlockwise.
CAUTION
l
Handle
halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the fog lamps
are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
6. To
install the bulb, perform the removal
steps in reverse.
NOTE
l
When mounting the cover, align the hook (F)
on the cover with the hole in the body.
Maintenance
8-38
8
To Next Page
Loading...
