WARNING
l
Make sure to remove the keyless opera-
tion key from the emergency key after
the engine is started.
If not removed, the keyless operation key
could fall to the floor, which could dis-
turb the pedal operation. Furthermore,
the keyless operation key could prevent
the driver’s knee airbag (if so equipped)
from inflating normally or could be pro-
pelled to cause serious injury if the air-
bag inflates.
NOTE
l
If
the emergency key is attached to a key hold-
er, it may become impossible to insert the key-
less operation key into the emergency key,
and it may prevent the engine from being star-
ted. When using the emergency key to start
the engine, first remove the key from the key
ring.
Starting the engine (diesel-powered vehicles)
E00308800109
1. Fasten the seat belt.
2.
Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal.
NOTE
l
On vehicles with the Auto Stop & Go
(AS&G) system, the starter will not operate
unless the clutch pedal is fully depressed
(Clutch interlock).
5. Place
the gearshift lever in the “N” (Neutral)
position.
6. While
pushing the lock release button (A), re-
move the cover of the ignition switch.
7. Insert the emergency key into the ignition
switch.
8. Insert
the keyless operation key into the emer-
gency key.
9. Turn
the emergency key with keyless opera-
tion key to the “ON” position. The diesel pre-
heat indication lamp will first illuminate, and
then after a short time go out, indicating that
preheating is completed.
Locking and unlocking
1-22
1
To Next Page
Loading...
